Low Odor High Solids Water Based Epoxy
Pricing & Options
AWF Water Based Garage Floor Epoxy
TrueLock simple Water Based Epoxy has low VOC's and low odor. It is sold in one gallon kits that covers 250-300 Sq. Ft. / Gallon. The addition of anti skid increases strength and traction. This is a NEW product launched 07/20/19 and will not match previous version
NEW TrueLock Water Based Epoxy --Medium Gray
SKU: TLWB15-MG
Price Each:
NEW TrueLock Water Based Epoxy --Beige
SKU: TLWB15-BG
Price Each:
Aliphatic Urethane Topcoat. VOC Compliant 1 Gallon. Covers 400 - 800 Sq. Ft. per gallon
SKU: TL356PAVOC-1
Price Each:
Ghostshield 1001 Eco-Etch *No Returns*
SKU: GS1001
Price Each:
GhostShield Eco-Etch 1001. DO NOT CONFUSE WITH PRIOR EcoEtch from Eco Saftey Products. This is a concentrated, environmentally friendly, acid etching solution. While it can etch up to 750 Sq. Ft. We find that 200-400 sq. Ft. is more practical for estimating. Typical concrete will need a dilution rate of 1:1 and net a total coverage of 400 Square Feet while Power Troweled Concrete will need a stronger product that has not been diluted and only cover 200 Sq. Ft. per gallon.
Please note this product cannot be returned due to shipping restrictions.
Application
Application
- Always test a small area before application to ensure the desired ratio, etch time, coverage rates, and to verify application technique.
- Before cleaning or etching, make sure the concrete is free of all oil, contaminants, grease, dirt, and rust stains (will not clean grease, oil, or rust spots.
- First, wet the substrate with water. Apply using a low-pressure pump sprayer. Allow the solution to sit on the substrate for three (3) to ten (10) minutes. Flush thoroughly with clean water. You do not need to neutralize after using Eco-Etch 1001.
Reconstitution
Only mix with water. Mix solution slowly in an open-top plastic container. Stir gently. The ratio varies by desired use: for a lighter etch, two (2) parts water to one (1) part Eco-Etch 1001; for a medium etch, one (1) part water to one (1) part Eco-Etch 1001 and for a heavier etch full strength.
Clean Up
Clean equipment and tools with hot soapy water. Unused or old material may be disposed of in a waste disposal site in accordance with local, state, and federal laws.
Best Performance
- Proper application is the responsibility of the user.
- Make sure the most current versions of product data sheets and SDS are being used.
- For professional use only. Keep out of reach of children.
Precautions/Safety
Avoid contact with skin, eyes, and clothing, do not take it internally. Use appropriate safety equipment during application and handling. Please refer to the safety data sheet (SDS) for additional precautionary instructions before use.
Anti-wear and Soft Texture Anti Skid -- Tabular Aluminum BULK 1# (.6 - 1# / gallon)
SKU: AntiSkid
Price Each:
All Weather Floors Industrial Floor Cleaner - 1 Gallon
SKU: TL915
Price Each:
All Weather Floors Industrial Floor Cleaner - 5 Gallon
SKU: TL915-5
Price Each:
5 Pounds 1/4 inch Torginol Flake Blend (non-stock manufacturer direct)
SKU: TORG5P
Base Price:
Price Multiple:
5 or more for quantity discount
5 Pounds Flakes Other Color/Size
SKU: GBCFLAKE5-Other
Base Price:
Justin′s Install Kit: 4 Roller Covers, 2-3″ Chip Brushes, Humidity Meter, Spiked Shoes, Roller Frame.
SKU: Justin
Base Price:
6-48203 9″ Rollers
1- Pr- Spiked Shoes
2- Roller Frame
48203 Phenolic Core 9″ Pro-Grade Woven Shed-Resistant Roller Cover - 3/8″ Nap
SKU: 48203-1
Base Price:
48405 Acme 9″ Roller Frame
SKU: 48405-1
Base Price:
46106 Polypropylene Spiked Shoes with 3/4″ Spikes (Pair)
SKU: 46106-1
Base Price:
Justin′s 18 Inch Install Kit: 4- 18″ Roller Covers, 2-3″ Chip Brushes, Humidity Meter, Spiked Shoes, Roller Frame.
SKU: justin18
Base Price:
This kit contains:
4-48203 18″ Rollers
2- 3″ Chip Brushes
1Pr- Spiked Shoes
1 18″ Roller Frame
Simple
Garage Flooring offers a wide range of epoxy and urethane based garage floor coatings. The TrueLock WB garage floor epoxy is as simple as it gets. Unlike traditional epoxy products, AWFWB is over 50% solids (by weight) but it is cut with water, not harsh solvents. You have an hour to work with the product, so you will not feel as rushed. It does not require a clear coat when a simple basic color is being installed. We offer an easy to work with, non-toxic prep solution that makes the whole project easy
Chemical Resistant
The WB epoxy offers a moderate level of chemical resistance. For example, if you spill gasoline on the product and clean it up within a couple of hours, it should not cause noticeable damage to the floor. Chemical resistance can be greatly improved by adding a top coat of our TL356 urethane. This has good resistance for an inexpensive system but does not compare to our high-end epoxy and polyurea systems.
Hot Tires
Perhaps the most frustrating thing for garage floor epoxy customers is having to protect it so it does not come up under the pressure and heat of hot tires. For best results against hot tire lifting you would want to do two coats with a spread rate of 260 Sq. Ft. / Gallon over a surface that has been etched. You will want to use 3/4# per gallon of our antiskid.
Finish in a Day
A two-coat system can easily be completed in a day.It Stinks Less
Our epoxy is made with water not solvents. That makes cleanup easy and it means your garage (or even your own home) will not have the intrusive odors caused by solvent-based epoxy products. We love our urethane-based coating products. For some of our customers, the odor is offensive. This is especially true in occupied homes when coating a basement floor. It can also be true when coating an attached garage floor. One thing we love about the water-based epoxy is despite its incredibly high quality and test ratings, it just does not have the harsh chemicals and odors of the other products we sell. That said, you still should not drink it or cover your self in it — just to be clear. VOCs 175 g/l
Simple Solid Colors But Be Flaky if You Choose
Our water-based epoxy system is designed for those who want a tough but simple garage floor epoxy. No flakes required. No topcoat. That does not mean you do not have options though. The system will absolutely accept broadcast media such as flake. It will need to be top-coated with our clear urethan.e
Simple & Affordable but Not Cheap
We would prefer not to sell you anything than sell you an inexpensive product that is going to fail. It is that simple. This is a high-quality epoxy product that is simply formulated differently from much of what is on the market. You can rest assured that while this is a simple and affordable way to epoxy coat your garage floor; It is the high quality our customers have come to expect from Garage Flooring. We also want to be clear that an inexpensive waterbased system will never perform at the level of our Polyurea or 100% solids systems. It is a lower-priced alternative that is much lower odor than Polyurea.
